|
|
| (8 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| Materials:
| |
|
| |
|
|
| |
| Beaglebone Black Industrial
| |
|
| |
| Logitech C545 webcam
| |
|
| |
|
| |
| Steps:
| |
|
| |
|
| |
| Installed Debian Jessie via a netinstall from [http://elinux.org/BeagleBoardDebian Elinux.org BeagleBoardDebian]. Used serial port. Migrated to Devuan. Installed Zoneminder using jessie-backports according to official install guide.
| |
|
| |
|
| |
| Industrial BBB was chosen, in the hopes of using it as a dashcam under winter conditions.
| |
|
| |
|
| |
| Camera works plugged into USB. Logitech camera works under the following settings
| |
|
| |
|
| |
| * Local
| |
| * MJPG
| |
| * 960 x 720
| |
| * PAL
| |
|
| |
| Total load with camera, gets about 960x720 3FPS, with .7 load on the server, in monitor mode. Making this a potential external ZM server.
| |
|
| |
| YUYV works with resolution of 320x240, but no higher. MJPG is able to get 320x240, 640x480, and 960x720.
| |
|
| |
|
| |
| This being an SBC, there is a additional interfaces, expansions (I2C, GPIO) to use in addition to the camera itself. Sensors can be added easily.
| |
|
| |
|
| |
|
| |
| Note: I ran into problems using this BBB with a long (>25 ft) ethernet cable. Network functions were slow, or failing. This could be a problem, if you were to use these as substitutes for cameras. It may have been my particular model (BBB Element14 industrial). A shorter cable resolved all issues.
| |
