Difference between revisions of "Escam"
From ZoneMinder Wiki
Jump to navigationJump to search
| Line 1: | Line 1: | ||
=QD300 settings= | |||
==In camera settings== | ==In camera settings== | ||
| Line 30: | Line 30: | ||
** Target colorspace: 32 bit | ** Target colorspace: 32 bit | ||
** Capture Width and Height | ** Capture Width and Height | ||
*** For primary stream: 1280 and 720 | *** For primary stream: 1280 and 720 | ||
*** For secondary stream: if you are using CIF, its 352 and 288 respectively | *** For secondary stream: if you are using CIF, its 352 and 288 respectively | ||
Revision as of 10:50, 2 November 2015
QD300 settings
In camera settings
QD300 allows you to configure both a primary and secondary stream. You can set it up in the "device config->Encode" section of the camera
In this example, I've enabled the primary stream and disabled the secondary stream. You can enable both. Note that I've set the FPS to 3 as its a good idea to reduce FPS in-camera and not ZoneMinder. Set it to a value that makes sense for you.
Error creating thumbnail: Unable to save thumbnail to destination
ZoneMinder settings
You can either configure the camera using FFmpeg or native RTSP
Configuring it via FFMPEG
Primary Stream
- General
- Source Type-->Ffmpeg
- Source
- Source Path
- For primary stream:
rtsp://<cameraip>:554/user=<username>&password=<password>&channel=1&stream=0.sdp - For secondary stream:
rtsp://<cameraip>:554/user=<username>&password=<password>&channel=2&stream=0.sdp
- For primary stream:
- Remote Method: RTP/RTSP
- Options: keep empty
- Target colorspace: 32 bit
- Capture Width and Height
- For primary stream: 1280 and 720
- For secondary stream: if you are using CIF, its 352 and 288 respectively
- Source Path
You don't need to change anything else
Configuring it via native RTSP
Will update this later, but in general, while it works, you will see constant ERRs logged while viewing the feed. So stick to FFMPEG - if you see smearing, switch to native RTSP
