Escam

I've tested QD300 so far. I am told QD900 will be the same

These are the settings for QD300.

In camera settings

QD300 allows you to configure both a primary and secondary stream. You can set it up in the "device config->Encode" section of the camera

In this example, I've enabled the primary stream and disabled the secondary stream. You can enable both. Note that I've set the FPS to 3 as its a good idea to reduce FPS in-camera and not ZoneMinder. Set it to a value that makes sense for you.

Error creating thumbnail: Unable to save thumbnail to destination

ZoneMinder settings

You can either configure the camera using FFmpeg or native RTSP

=Configuring it via FFMPEG

• General
  • Source Type-->Ffmpeg
• Source